I am interested in this because I can see the potential to increase the speed to 100 mm/s or even more and keep the wall and top/bottom speeds at say 50mm/s and not loose any quality but reduce the time. Normally if I were to print at 20 mm/s instead of 50 mm/s then I would reduce the nozzle temperature. However isn't there a problem with nozzle temperature? I can understand that reducing the speed for the walls and the top/bottom should improve the print quality. I'll definitely look at that and see if that is where the delay is. Setting those to 50 will improve print speed from 46 min to 24 min. Cura 2.1 uses wall speed of 40, outer /inner wall of 30 and top/bottom speed of 20. I don't even think there are much retractions in this print.Ĭhanging the top/bottom does have a dramatic impact.
![cura 15.04.6 download dmg cura 15.04.6 download dmg](https://i.ytimg.com/vi/qdOPFIbOJHQ/maxresdefault.jpg)
Window (the NWA3D A5 does not have a heated bed).į. Make sure the Heated bed checkbox is unchecked in the Machine settings
![cura 15.04.6 download dmg cura 15.04.6 download dmg](https://best3dprinter.stan-tech.com/wp-content/uploads/2018/01/cura-15.xx_.jpg)
![cura 15.04.6 download dmg cura 15.04.6 download dmg](https://www.imade3d.com/wp-content/uploads/Screen-Shot-2019-08-27-at-17.48.18-1080x595.png)
Make sure the filament diameter is 1.75mm and the flow rate is 100%.Į. For PLA, they should be set to 30–50mm/sĭ. (high-quality prints) and 0.3mm (low-quality prints).Ĭ. Make sure that the layer height is between 0.1mm Making good contact with the build surface, and isn’t too big for the buildī. Make sure the print is centered in the build area, Here are some steps to make sure your Cura settings are correct.Ī. Sometimes, models don’t print correctly because the settings in the G-Code are Cura 15.04.6 Slicer settings Cura Download: Ultimaker Cura All Versions NWA3D A5 Video Tutorial: